With ZipCabs you move the adjustable shelves to any location desired
              SHELF SYSTEM ASSEMBLY INSTRUCTIONS         Page 1     Go To:  Page 2
        Three part clip assembly consists of:
(1) support with machine screw, 
(2) stabilizer -- to retain the spring and hold down on top of shelf,
(3) spring that forces the support and stabilizer to grip the shelf.

The clip set	Spring compressor	Clips with lips open	Top of unit

These instructions will help if you take the ZipCab clip assembly apart or
need to install the clip set onto the rail.

You need a Phillips screwdriver:

1. Install Clip Sets --lay unit on its side.
    
   Insert stabilizer in the channel, making sure that it is seated firmly in the
   recess at bottom of the channel and moves freely within the channel. 
   
    Move the stabilizer to the cutout portion of the channel that is directly
    under the top shelf or above the bottom shelf.
   
   To complete the assembly, hold down on the bottom of stabilizer so that it
   does not move. Place bottom edge of support clip against the spring and
   push down to compress the spring enough to seat the support clip inside the stabilizer. Slide the completed assembly onto the rails.
    
2. Open the lips between the support and stabilizer using the spring compressor:
   Place your thumb over the label on the spring compressor and place arrow
   end on top of protruding lip of support clip. With other hand, push on bottom
   of the stabilizer clip to compress the spring enough to insert spring compressor into opened lips of the assembly.
   
   Move clip assembly close to its final location. Tighten screw.
   Remove the spring compressor, leaving assembly's lips in open position

Do not over tighten — Do not use power screwdriver

STEPS 1 AND 2 HAVE BEEN COMPLETED -- GO TO STEPS 3 AND 4 FOR INSTRUCTIONS TO INSTALL THE SHELVES